About this model:
The John Deere 24T is a classic small square baler known for simple, dependable twine-tie operation. Below are the key factory-style specifications and general dimensions for the 24T baler , including bale size, pickup width, plunger speed, PTO requirements, and approximate weight.
John Deere 24T Specifications
| Feature | Specification |
|---|---|
| Auger Diameter | 16 in. |
| Auger Length | 49 in. |
| Bale Cross-Section | 14 in. x 18 in. |
| Bale Length | Adjustable 12 in. to 50 in. |
| Compression Chamber Length | 44 in. |
| Feeder Opening Dimensions | 13 in. x 21 in. |
| Flywheel Diameter | 27 in. |
| Height (Maximum) | 64 in. |
| Overall Length (With PTO) | 17 ft. 1/2 in. |
| Overall Length (With Engine) | 17 ft. 10-1/2 in. |
| Overall Width | 8 ft. |
| Pickup Cylinder Diameter | 12 in. |
| Pickup Width (Inside) | 53 in. |
| Pickup Width (On Flare) | 62 in. |
| Plungerhead Stroke | 28 in. |
| Plungerhead Speed (Normal, Under Load) | 65 strokes per minute |
| Plungerhead Speed (Maximum, No Load) | 72 strokes per minute |
| PTO Shaft Speed | ASAE-SAE Standard — 540 or 1000 rpm |
| Recommended Tractor Size | 2-plow tractor or larger |
| Transmission | Gears — steel cut, enclosed |
| Transmission Capacity | 2-3/4 qts. SAE 140 |
| Weight (Approx., With PTO) | 2400 lbs. |
| Weight (Approx., With Engine) | 2650 lbs. |
Engine Option (Wisconsin)
| Feature | Specification |
|---|---|
| Engine | Wisconsin Model THD |
| Horsepower | 17 horsepower |
Tires
| Position | Tire / Rating |
|---|---|
| R.H. (30 lbs. pressure) | 15 x 4.00 — 4-ply |
| L.H. (40 lbs. pressure) | 15 x 6.40 — 6-ply |
Note: Right-hand and left-hand sides referenced in the original manual are determined from a position at the rear of the machine facing in the direction of travel.
Need the John Deere 24T Twine-Tie Baler operator’s manual?
Download the PDF here →