Massey Ferguson MF 1500 and MF 1800 Tractor Specifications

Specs HubMassey Ferguson › MF 1500 & MF 1800

Complete specifications for the Massey Ferguson MF 1500 and MF 1800 articulated four-wheel-drive tractors, transcribed from the specifications section of the factory operator's manual (Form No. 1448 173 M5, dated 9/73). Both share an 8-cylinder, four-stroke, direct-injection 90° V diesel with a common 4.5 inch bore. The MF 1500 uses a 4.5 inch stroke for 573 cu. in. at 17:1 compression; the MF 1800 uses a longer 5.0 inch stroke for 636 cu. in. at 16.5:1.

Drawbar horsepower was independently tested at Nebraska: 153.8 hp for the MF 1500 (Test No. 1086) and 183.6 hp for the MF 1800 (Test No. 1087), both in rated gear. Drive runs through a 14 inch single-disc foot-operated clutch to a basic 3-speed transmission with a standard/overdrive range ahead of the transmission and a hi-lo range in the transfer case, giving 12 forward and 4 reverse speeds. The hydraulic system is open center with a 2-spool control valve and two 22 gpm gear pumps, one for the auxiliary hydraulic system and one for steering and transmission lubrication.

Engine

Engine
Specification MF 1500 MF 1800
Type 8-cylinder, four stroke, direct injection, 90° V
Cylinder Bore 4.5 inches (114mm)
Piston Stroke 4.5 inches (114mm) 5.0 inches (127mm)
Total Displacement 573 cu. ins. (9.4 liters) 636 cu. ins. (10.4 liters)
Compression Ratio 17 to 1 16.5 to 1
Firing Order 1-2-7-3-4-5-6-8
Valve Lash, cold, exhaust 0.025 inch (0.64mm)
Valve Lash, cold, inlet 0.015 inch (0.38mm)
Low Idle 800 rpm ± 25
Maximum Full-Load Speed 3000 rpm 2800 rpm
High Idle 3210-3310 rpm 2970-3070 rpm

Fuel System

Fuel System
Type Gravity flow and pressure fed
Filter Full flow with replaceable element
Fuel Injectors Multi-hole type

Electrical System

Electrical System
Batteries Two, 12 volt, 96 amp-hr., negative ground
Specific Gravity, fully charged 1.260 to 1.300
Starter Switch Key operated
Starter 12 volt, 4-pole
Alternator Continuous output, diode rectified A.C. type
Regulator Voltage-current limiting relay type

Brake

Brake
Type Hydraulically actuated, 12 in. internal expanding shoe brake on the drive line, self-adjusting

Hydraulic System

Hydraulic System
System Open center, 2-spool control valve
Pumps Two 22 gpm gear pumps, one supplying the auxiliary hydraulic system, the other supplying steering and transmission lubrication

Power Train

Power Train
Clutch 14 in. diameter single disc, foot operated
Transmission/Transfer Case Basic 3-speed transmission with standard/overdrive range ahead of the transmission and a hi-lo range in the transfer case. Constant mesh gears with sliding couplers and a transmission brake, giving 12 forward and 4 reverse speeds.

Capacities

Capacities
Component U.S. Imperial
Fuel Tank 120 gals. 100 gals.
Cooling System 48 qts. 39.8 qts.
Crankcase, with filter change 12 qts. 10 qts.
Center Housings, front and rear 3.5 gals. 2.9 gals.
Hydraulic Reservoir 15 gals. 12.5 gals.

Dimensions

Dimensions
Wheel Base 120 inches
Overall Length 210 inches
Overall Height, top of cab, on 23.1 x 30 tires 130 inches
Overall Width, on 23.1 x 30 tires 95 inches
Tread Width 68 to 88 inches
Turning Radius Approximately 17 ft.; 19 ft. with 23.1 x 34 duals
Ground Clearance, minimum 15 inches
Shipping Weight, with single tires 16,000 lbs.
Maximum Operating Weight, MF 1500 22,500 lbs.
Maximum Operating Weight, MF 1800 24,500 lbs.

Tires

Tires
Single 18.4 x 30 R1, 6 ply; 18.4 x 38 R1, 6 ply; 23.1 x 30 R1, 8 ply; 23.1 x 34 R1, 8 ply; 23.1 x 30 R20, 8 ply; 23.1 x 34 R20, 8 ply; 30.5 x 32 R1, 10 ply
Dual 18.4 x 30 R1, 6 ply; 18.4 x 38 R1, 6 ply; 23.1 x 30 R1, 8 ply; 23.1 x 34 R1, 8 ply

Horsepower — Drawbar

Horsepower, Drawbar
MF 1500, maximum power in rated gear 153.8 hp (Nebraska Test No. 1086)
MF 1800, maximum power in rated gear 183.6 hp (Nebraska Test No. 1087)

Notes:
All five capacity rows in this manual convert correctly, within half a percent of the precise Imperial factor. No unit or rounding errors found.
All specifications transcribed from the specifications section of the Massey-Ferguson MF 1500 and MF 1800 operator's manual, Form No. 1448 173 M5, dated 9/73, originally published by Massey-Ferguson. Verify against your tractor's serial number before ordering parts or setting clearances.

Need the complete Massey Ferguson MF 1500 / MF 1800 operator's manual?

Get the full manual as an instant PDF download, covering controls and instruments, operation of the articulated four-wheel-drive chassis, transmission and transfer case use, the hydraulic system, the lubrication and maintenance schedule, and the specification section reproduced above.

Download the Operators Manual

Other Massey Ferguson tractors covered on this site:

Manual code: 1448 173 M5

Specifications last reviewed